ACT-LABS gun system Specifications download pdf (Page 3)

All other trademarks are the property of their respective owners

Button Layout

The trigger button, when pulled, moves the cursor to where the light gun is

pointed on the Monitor’s screen. It acts exactly like a left mouse button. The

trigger button will cause the Monitor to flash white. This is required for the

light gun to determine its position on the Monitor and cannot be avoided. The

reload button is at the back and on the right of the light gun. It acts exactly

like a right mouse button. Reloading can also be done by shooting the light gun

away from the screen. This reload button can be re-mapped for other functions

depending on the game.

A 3-position mode switch is located on the left side of the light gun. There are

three modes available: calibration mode, one-player mode and two-player mode. The

calibration mode (bottom position) is for learning the resolution and refresh rate

of the Monitor. It will make the light gun shots more accurate.

Note for Original(One-player) PC USB Light Gun units only:

Only a 2-position mode switch is located on the left side of the light gun and

does not have the two-player mode. It switches between calibration mode and light

gun mode. Calibration mode is in the bottom position and the light gun (one-player)

mode is in the upper position.

The one-player mode (middle position) is the default mode. This mode lets you play

with the light gun as a single player. In one-player mode, the trigger acts as

mouse button 1 (Left Mouse button) and reload as mouse button 2 (Right Mouse

button).

The two-player mode (top position) lets you play as a second player in games that

support the ACT LABS PC USB Light Gun two player mode. In this mode, the trigger

button acts like the 3

mouse button while the reload button acts like the 4

mouse button.

Note:

The single player version is always defaulted as the 1

player if used in

conjunction with a 2 player version light gun. In this case make sure the 2

player version is configured as two player mode.

Gun Calibration

The mode switch located on the left side of the ACT LABS PC Light Gun enables you

to calibrate the gun for use with your PC. Before proceeding with the light gun

calibration, be sure to expand the image on the Monitor so that it fills up the

entire screen area. Move mode switch to the bottom position. This will activate

calibration mode and the Monitor should blank completely white.

1 2 3 4 5 6 7 8

No comments

ACT-LABS gun system Specifications Page 3